Ortur Laser Master 2 | Three Belt Tensioner Set for LM2 Laser Printer

Description

This set of 3 Belt tensioners for the Ortur Laser Master 2 (LM2) let's you adjust the belt tension on your DIY laser printer.
Finally you can achieve perfect tension :)
Hand tighten or hand loosen the threaded knob to make the adjustment.
DO NOT OVER TIGHTEN YOUR BELTS!!!
Please refer to this video for tension
https://m.youtube.com/watch?v=yAFyZZX8RUk&feature=youtu.be
You may need to Replace your belts with longer belts, to see if your belts are long enough-
You need to remove the washers that previously Locked your belt on the side that you install the tensioners
X belt needs to be at least 625mm
Y belt needs to be at least 640mm
These are the minimum if you are cutting belt off a roll leave a little extra
GT2 timing belt 6mm wide is what you need -
it is not included in this listing
If you need the belts as well you can buy the bundle that has them included here -
http://www.ebay.com/itm/333868390714
--
Remix of the belt tensioner by Misterguru
https://www.thingiverse.com/thing:3319649